First look at an inverted T-Shape staircase with a straight and a curved flare:

Since I've been focusing on updating the stair module the last week I've had quite a number of requests for various things.  One request is the ability to flare out the bottom of the stairs.  I can add in this functionality however to start with it would be very rudimentary (just a modification to the treads and risers as shown):





I'm not entirely sure how one would go about in-fill framing the flared portion, nor do I think there is any established or standard way to do this, I could be wrong.  Any thoughts or ideas in this regard?   I should probably ask first if this is something that you would all want or even need.

**Tutorial 55** - Complex Stairs (9:57 min.)

Version 3.7.8 - 12.17.2024
- Added the following L-Shape and U-Shape winders: 2, 3, 4 and 6 step.
- Added the following two step angle winders: 30, 45 and 60 degrees.
- Added the following T-Shape stairs with landing: T, TL, TR
- Enabled double landings for all landing and winder configurations.

First look at double landing configurations with 2-step and 3-step L-winders:

First look at a two landing staircase:

Tutorial 54 - Stairs with Landings (13:27 min.)

Version 3.7.7 - 12.12.2024
- Added a "Calculated Parameters" section to the edit menu of the stair module.
- Added the ability to create L-Shape, U-Shape and Straight runs of stairs with landings.

Switching between landing and no-landing:

Tutorial 21 - Roof Sheathing (7:13 min.)