Tutorial 23 - Joist Removal (8:06 min.)

Version 1.0.2b - 05.23.2025
-Updated the joist removal function for more granular usage when working with staggered joists.

I apologize for all of these micro updates, I would have preferred to roll this out after adding a few more features etc... However, the user who requested this specific ability obviously needs it to complete their project so it is simply a matter of expediency.



Now one can not only specify a single line of joists to remove but also remove specific joists from a given line, see screenshot above and note the syntax in the Remove Joists field.

Turn on the framing callouts.

IS THERE A GOBAL SETTINGS FOR THE SHEARWALL i DON'T SEE IT, BECAUSE MINE DOSN'T LOOK LIKE Nathaniel

WENT IN GLOBAL AND TURNED EVERYTHING I SEE
IS THERE ANYTHING I MISSED

Version 1.0.2 - 05.22.2025
- Enabled multi-ply floor headers for openings.
- Enabled variable lengths for staggered joists.





You can now enter in a single value for the joist length or you can enter in a list of lengths deliminated by commas. This update per user request.

Did you turn on these other options in the menu?

how come when
Nathaniel puts in a shear wall it puts the nailing pattern info and everything else mine just put sw1

The Floor Opening toolbar will now contain a sixth tool called "Stretch Header" which will allow the user to stretch the opening headers in a more intuitive fashion:



I'm not really wanting to add more icons to my already bloated toolbars but I feel like this will be a very worthwhile tool and it will almost certainly makes everyone's life a little easier when it comes to these openings.

I've been giving the feedback I received thus far on the new opening tool some serious thought  and after further testing I can see that adjusting the header extensions to reach out and grab the correct joist is probably the biggest bottle neck in the process, if you can call it that.

Below is an example of a six sided L-shaped opening in a floor.  It has three headers and three "trimmers".  Note that headers run perpendicular to the joists however the opening tool really makes no distinction between headers and trimmers, they all have the same ten parameters.



I had to make five entries to adjust the headers to meet the I-Joists as shown.  Really not that difficult but somewhat time consuming and tedious in my opinion.  The solution to this problem could be to have the plugin somehow detect the nearest joist and auto-extend to it.  However, I feel that such an algorithm would be overly complicated and probably not very robust.

The other option would be to create a "Header Stretch" tool that allow the user to simply mouse over the header, select one end or the other and then stretch it to the desired location.  This tool would be very similar to the "Wall Stretch" tool that is part of the Wall plugin.  Rather than navigating through the labyrinth of menus one could simply adjust each end with only three mouse clicks.

Again, I have my work cut out for me.

I've also realized that it is not readily apparent to the user which header is which.  I may need to incorporate some sort of labeling option that will assist with this.